F32 Polyurethane Resin, 100g
The F32 polyurethane resin resembles a bit of F190 resin produced by Axson.
It can be used in the same way for product and tool manufacturing.
However, F32 Polyurethane resin requires more expertise; therefore, we recommend it to modellers and prototype manufacturers with more experience.
Typical features:
- Concise 1.5 min pot time, the resin must be mixed and settled to the mould.
- Quick tool disassemble, 15-20 minutes
- The price is a little higher than F190.
- Mixing right 100:100% by weight
- Very low viscosity, almost water-like, good space filling
- Best choice for casting fragile elements
- Odorless
- It can be painted well
- Silicone moulds are very resistant to this resin.
Further technical parameters and application guide will be found on the detail tab.
Your Dynamic Snippet will be displayed here...
This message is displayed because youy did not provide both a filter and a template to use.